Home / Garage Doors / Drives for Revolving Doors / Characteristics

Characteristic

Drives for revolving doors

For automation of the most common two-wing revolving doors, a set of drives is supplied that contain two motors as standard, the drive unit, sensor, antenna, receiver and control unit.

The motors are installed in the lower part of the door's permanent pillar from the inside and are simultaneously connected to the gate wing

An open signal placed either by the remote control, key starter or other kind of activator is received by the antenna and/or receiving unit of the control panel that activates the revolving gate wing.

The security sensor sends a signal to the control unit in the event of an obstruction, causing the gatewings to stop, and to switch to reverse. As an additional security measure it is possible to use warning lights that are lit during the whole activation drive period.

Single winged doors are automated in the same way. The standard drives are constructed for the passing width of 3.6m. They are also supplied for revolving doors with a passing width of up to 10m.